Toyota Land Cruiser 80 Series Front Brake Caliper Repair Rebuild Kit 54mm (1998 - 2006)
- Stok Durumu: Stokta Var
- Marka: Ithal
- Stok Kodu: KRC4614
Bu Ürünü Sevdiklerinize Önerebilirsiniz
Toyota Land Cruiser 80 Series Front Brake Caliper Repair Rebuild Kit 54mm (1998 - 2006)
Engineered specifically for the legendary Toyota Land Cruiser 80 Series (1992 - 1997 / HDJ80, HZJ80, FZJ80 Chassis) 4x4 off-road lineup, this premium 54mm Front Brake Caliper Repair Kit is designed to eliminate hydraulic fluid leaks, resolve caliper seizing, and overhaul sticking front brake 4-piston mechanisms.
Composed of high-grade, heavy-duty rubber seals and protective dust boots, this rebuild kit restores tight hydraulic pressure during harsh trail driving, heavy-duty hauling, or expedition cycles, resolving spongy brake pedal issues and ensuring your front braking system operates with factory-spec efficiency.
Why Should You Rebuild Your Land Cruiser 80 Front Brake Calipers?
Due to frequent off-road use, deep water crossings, mud, sand, and overland driving, the front calipers on the Land Cruiser 80 series undergo intense environmental and mechanical stress. Over time, the protective piston dust boots can get torn or degraded. This allows moisture and abrasive debris inside the housing, causing the 54mm front caliper pistons to rust, seize up, and drag against the brake rotor.
Common symptoms of a failing front caliper seal include:
The vehicle pulling sharply to one side during braking due to an uneven piston stick in the 4-piston assembly.
Excessive wheel and hub heat, accompanied by power drag and decreased fuel economy as the brake remains partially applied.
Visible brake fluid leaks around the front caliper assembly and dropping fluid reservoir levels.
Excessive brake dust, burning odors, and uneven or premature wear on the front brake pads and heavy-duty rotors.
This 54mm piston diameter seal kit allows you to completely rebuild your existing assembly, bypassing the extreme cost of purchasing a completely new 4x4 front caliper housing.
Key Product Features:
Precise 54mm Fitment: Designed as an exact direct match for Toyota Land Cruiser 80 series front disc brake calipers with 4-piston setups.
Premium Off-Road Elastomers: Superior resilience against mud, water immersion, heavy brake fluids, and high thermal cycles from heavy overland vehicles.
Comprehensive Front Component Set: Includes high-quality piston dust boots, internal hydraulic pressure seals, and retaining clips for a full service.
Cost-Effective Engineering: Restores maximum braking safety efficiently without discarding the expensive original caliper body.
Vehicle Compatibility & Technical Specifications
Specifications & Rebuild Data Table
| Specification | Details / Values |
| Product Name | Front Brake Caliper Rebuild Kit (Seals & Boots Set) |
| Piston Diameter | 54 mm |
| Compatible Vehicle | Toyota Land Cruiser 80 Series (HDJ80 / HZJ80 / FZJ80 Platforms) |
| Model Years | 1992 - 1997 |
| Placement on Vehicle | Front Axle (Fits both Left and Right sides) |
| Engine Configurations | 4.2 TD (1HD-T / 1HD-FT), 4.2 D (1HZ), 4.5 24V (1FZ-FE) (Fits All 54mm 4-Piston Models) |
Installation Tip: Because front axle braking performance is critical for heavy 4x4 reliability and safety, always apply a thin layer of specialized high-temperature brake cylinder assembly paste to the new rubber seals and the pistons to prevent tearing during insertion. Perform a complete brake system bleed afterward.